Technical Features

Navigation:  Hardware and Accessories > Discontinued Accessories > Sensor Link >

Technical Features

prev main next

Navigation:  Hardware and Accessories > Discontinued Accessories > Sensor Link >

Technical Features

prev main next

Please wait. Due to its content this page might take a while to load...

From one unit there can be used simultaneously:

2x 12V industrial encoder inputs with internal or external reset (GPI) with 5-pin M12-Connectors,
2x 0-10V analog inputs and
8x GPI contact closures

Since the SensorLink is based on TCP/IP communication (outputs TCP/IP at variable frequency between 50 and 5000 Hz), multiple units can be used at the same time.

The internal sample rate reads incoming data at 7 kHz to allow high resolution encoder inputs to be used for accurate motion sensing.

_img545

The front panel shows the Neutrik Ethernet input jack as well as the 4 pin XLR 12V power input.

_img546
On the rear side you will find the connection for encoders (E1 & E2, please use 5-pin M12-Connectors, Pin Connections: 1= +Volt, 2=B, 3=0Volt, 4=A, 5= N Index), analog devices (A1 & A2) and contact closures S1 – S8).

RESET
As the unit can be programmed for various encoder step count settings or remote rest indexing a reset button is provided to restore the factory settings of the unit.

STATUS LED
Three status LEDs give feedback information of the current state of the unit.