Serial Link Output

Navigation:  Widget Designer > Nodes > Output Nodes > Connections Output >

Serial Link Output

prev main next

Navigation:  Widget Designer > Nodes > Output Nodes > Connections Output >

Serial Link Output

prev main next

Please wait. Due to its content this page might take a while to load...

The Serial Link output node connects to a serial link via the connection managers TCP ID. Incoming values can be compared to send ASCII or Byte packets to any of the four serial ports of the connected Serial Link. All 24 GPI contact closures can be mapped and assigned to input values as well 0 is off, 1 is contact closed.

_img867

Node Properties:
TCP Connection ID:
Enter the TCP Connection ID. The TCP Connections can be found and setup in the Connection Manager.

Update:
Choose if the output should be updated either "On Change of Input Value Only" or permanently. It is recommended for performance reasons to choose "Update on input value change only".

If:
Choose the first input node from list or enter numeric value. This input will be compared to the second input.
Choose the Operator.
Choose the second input node from list or enter numeric value.

Then send:
If the operation is True, the True script will be executed. You have the possibility to assign a different true send command for each Serial Link port. The topic Script Language explains commands and how to use them in more detail.
See here a list of all commands.

Else send:
If the operation is False, the Else script will be executed. You have the possibility to assign a different else send command for each Serial Link port.

GPI Outputs:
All 24 GPI contact closures can be mapped and assigned to input values as well 0 is off, 1 is contact closed.

Tick the check box to Mute Node on Page Change.