Patch Settings

Navigation:  Tools and Other Software > Matrix Patcher > Matrix Patcher User Interface >

Patch Settings

prev main next

Navigation:  Tools and Other Software > Matrix Patcher > Matrix Patcher User Interface >

Patch Settings

prev main next

Please wait. Due to its content this page might take a while to load...

matrix-patcher_patch-settings-menu

 

matrix-patcher_show-info

The Patch settings allow you to change the Patch View.

[Zoom]:
You may set a higher zoom factor to zoom into the patch (by default the zoom factor is set to 1).

[Center]:
Press [Center] to move the patch’s center point into the center of the user interface. This can be helpful after dragging the patch.

[Patch Width & Height]:
The patc

hes size is displayed here.

[Show Info]:
When enabling this option, the DMX Addressing will be shown on the patch for each fixture.
In the left image you see two fixtures. Their DMX address is shown in the respective upper left corner.
The lower fixture is highlighted blue as it is currently selected.

 

[Show BG]:
A background image (for example a floor plan) may be displayed on the patch, this can be helpful for some patches.
To do so, load a background image (see Edit Menu) and enable the option [Show BG].

[Show Pixel Grid]:
Uncheck this option if you don’t want to see the pixel grid in the patch.

Please note that with some patch sizes and zoom factors the pixel grid can’t be displayed.