Parameter Keyframe Inspector

Navigation:  Pandoras Box > User Interface - Master > Tabs Overview > Inspector >

Parameter Keyframe Inspector

prev main next

Navigation:  Pandoras Box > User Interface - Master > Tabs Overview > Inspector >

Parameter Keyframe Inspector

prev main next

Please wait. Due to its content this page might take a while to load...

The Parameter Keyframe Inspector allows you to set up the following:

inspector_param-key_01inspector_param-key_02The left image shows the standard inspector for a keyframe.

The right image shows the multi-inspector of three keyframes that belong to a preset.

Note the additional drop down menu where you can choose that keyframe the below information should refer to. The keyframe's name in the menu consists of:
[2.1] - the site and layer ID it belongs to,
Opacity Event - the parameter it belongs to, and
@0:00:00:05:15 - the time it belongs to.

Underneath the drop down menu you see the information that you have two more preset keyframes selected.

Under the horizontal line the standard inspector lists all customizable control and property settings.

- Name:
Informs you about the parameter's name the selected keyframe belongs to. In case the selected key belongs to a preset, the preset's ID and name are listed as well.

- Time:
To change the timecode of the key, enter the new timecode using the following syntax: enter eg. 0:00:06:09 or just 609 to get the new time 0:00:06:09.
To just add eg. two seconds to the current time, enter "++200", to subtract eg. two seconds, enter "--200".

- Time in Clip
To change the Time of the key inside the clip, enter the new time using the following syntax: enter eg. 0:00:06:09 or just 609 to get the new time 0:00:06:09.
To just add eg. two seconds to the current time, enter "++200", to subtract eg. two seconds, enter "--200".

- Curve Type: choose between Linear (Standard), Bezier, Bezier Corner, Constant and Stop. To edit the curves please open the Curve Editor, here the different types are explained and illustrated.

- Value:
To change the key´s value, enter the new value or move the fader.