OSC Output

Navigation:  Widget Designer > Nodes > Output Nodes > Connections Output >

OSC Output

prev main next

Navigation:  Widget Designer > Nodes > Output Nodes > Connections Output >

OSC Output

prev main next

Please wait. Due to its content this page might take a while to load...

The OSC Single Message Output node enables you to send data via the Open Sound Control Protocol.

Unlike the OSC Single Message Output node which only allows sending messages with one value, this node can processes bundled OSC messages with up to 17 values.

A UDP Broadcast Input Connection is required, see Connection Manager.

This node can be found under Nodes > Output > Connections > OSC Output

wd_nodes_output_osc

Node Properties

UDP Connection:

Enter here the ID of your UDP connection.

On Change of Input Value Only / Update permanently:

Choose here whether the current value is supposed to be sent permanently or only once when it changes.

Message:

Choose an input node from the drop-down or enter a numeric value for each value that should be bundled in the message. You can transmit up to eight floats (i.e. floating point values) plus eight integers as well as one string value per message.

Address:

Enter here the address of your OSC message, e.g. /synthesizer/filter/abc

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).