ODSL 30 Input

Navigation:  Widget Designer > Nodes > Input Nodes > Devices Input >

ODSL 30 Input

prev main next

Navigation:  Widget Designer > Nodes > Input Nodes > Devices Input >

ODSL 30 Input

prev main next

Please wait. Due to its content this page might take a while to load...

The ODSL 30 Input node lets you read out distance data from the optical distance measuring sensor ODSL 30 via a local COMPort connection (RS232). The COMPort Connections can be found and setup in the Connection Manager.

_img778

Node Properties:

COM Connection ID:
Choose the COMPort Connection ID to listen to. The COMPort Connections can be found and setup in the Connection Manager.

The following settings need to be used:
600/8n1 (Baud Rate: 9600, Parity: None, Data Bits: 8,Stop Bits:1).

Value Range:
The range defines the jump point of a maximum value back to zero.
Enter the range in mm. This is only important for correct calculation of delta values when using as incremental length count. 

The Node generates the following output:

- ODSL 30 RS 232 Value

- ODSL 30 RS 232 Delta