Normalize Filter

Navigation:  Widget Designer > Nodes > Filter Nodes > Math Filter Nodes >

Normalize Filter

prev main next

Navigation:  Widget Designer > Nodes > Filter Nodes > Math Filter Nodes >

Normalize Filter

prev main next

Please wait. Due to its content this page might take a while to load...

The Normalize Filter node normalizes the incoming value. The input is mapped on a value between 0 and 1, where Min represents the value mapped on 0 and Max represents the value mapped on 1.

Values outside the range of Min and Max will be normalized with modulo(input/(Max-Min)), normalizations of values smaller than Min will have a negative sign.

The node can be found under Nodes > Filter Nodes > Math > Normalize

wd_nodes_filter_normalize

Node properties

Input:

Choose an input node from the drop-down or enter a numeric value.

Min:

Enter the numeric value that should be mapped to 0.

Max:

Enter the numeric value that should be mapped to 1.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The Node generates the following output:

- Result