Node Parameter

Navigation:  Widget Designer > Nodes > Output Nodes > Widgets Output >

Node Parameter

prev main next

Navigation:  Widget Designer > Nodes > Output Nodes > Widgets Output >

Node Parameter

prev main next

Please wait. Due to its content this page might take a while to load...

Similar to the scripting command WDNodeSetParam, this node allows you to control any node parameter. Please note that changing a node source for a filter or output node with this node will result in setting a numeric or string value for this parameter. Remotely changing the node source is only possible with the command WDNodeSetParamSource.

This node can be found under Nodes > Output > Widgets > Node Parameter

wd_nodes_output_node-parameter

Node Properties

Node:
Enter here the ID of the node.

Parameter:
Enter here the ID of the parameter you want to change. The ID is displayed as small superscript number behind the parameter value.

Value:
Choose an input node from the drop-down or enter a numeric or text value.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).