NET Link Software

Navigation:  Hardware and Accessories > NET Link >

NET Link Software

prev main next

Navigation:  Hardware and Accessories > NET Link >

NET Link Software

prev main next

Please wait. Due to its content this page might take a while to load...

This chapter explains the software settings for controlling the NET Link and getting information from it. Please see the introductory chapter for other information.

Software-wise the NET Link is included in the Widget Designer. The communication between WD and the device is based on an ethernet connection, not USB.

Nodes > Input > Devices > ... or Nodes > Output > Devices > ...
Relay Output node: receiving information from other nodes and controlling the connected NET Link, if it is mounted with (digital) relay output boards
 
Calibration Link Input node: receiving information from the connected Calibration Link or NET Link with analog input board for fibers; values are transferred to other nodes; the Calibration Input works with the tool "Projector Calibration Manager"
 
NET Link Input node: receiving information from the connected NET Link (or Calibration Link) according to the input boards and  transferring this information to other nodes

All nodes are controllable with node commands. Simply start a script with "Node1." for example, and Widget Designer will offer available commands. Using them, the NET Link input node turns into an output node as well. For instance, this command closes a relay. Node2.SetRelayDigitalBus1(ID,State)

wd_nodes_input_calibration-link wd_nodes_input_net-link wd_nodes_output_relay-output-link