Please wait. Due to its content this page might take a while to load...
In the middle of the Main Window the loaded master file is shown, which is repeated at the left, top, right and bottom side. This allows you to wrap the Output Regions around top/bottom or left/right. This is important for 360° Panorama / Sphere content overlap setups.
You may set up any amount of Output Regions, using the right-click menu or the create mode (see Toolbar). In the example above two Output Regions were created (green and red rectangle). Both have the size 1024x768 px. When exporting the master file, there will be a separate file created for each of the Output Regions.
The right-click menu inside the Main Window:
The right-click menu gives you access to
•Create an Output Region: Choosing Custom Size will enable you to span a rectangle in the Main Window. Choosing one of the pre-defined sizes you just have to define the position of the Output Regions top left corner by clicking into the Main Window.
•Move existing Output Regions.
•Drag the whole View around (incl. Masterfile and Output Regions).