Please wait. Due to its content this page might take a while to load...
The Jog Shuttle Controller is available to control up to two sequences.
Based on the selected sequence (use the select button for each sequence) the top 16 cue buttons let you go to 16 cues directly.
Based on the selection, use the Jog Shuttle controller to navigate back and forth through the timeline.
The fader on the left will control one sequence; the fader on the right will control a second sequence.
In order to map the faders to sequences and buttons to cues in Pandoras Box, please open the Configuration tab > Controller Setup.
SELECT (Button above fader):
Selects the sequence. The blue led on the button will light as indicator for the selection.
As soon as a sequence is selected, all Cue Buttons as well as the Jog Dial and the Playback Buttons are linked to this sequence!
LED light status:
Blue LED is on: Sequence is selected.
Red LED is blinking: Sequence status is “Play”
Red LED is on: Sequence status is “Pause”
Controls the sequence opacity.
Fader position on top = Opacity FULL
Fader position at bottom = Opacity 0%
PLAY/PAUSE (Button below fader):
Toggles the Sequence between Play and Pause. This Play/Pause Button can be used without having the sequence selected via the SELECT-Button.
For each sequence you may assign the 16 Cue Buttons via the Controller Setup Tab in Pandoras Box.
Depending on the selected sequence, the Cues Buttons are linked to this sequence.
The last Cue Button pressed will light up in blue.
The Jog Dial allows scrolling through the selected sequence:
The inner knob allows scrolling frame by frame, the outer know does a faster scrolling.
Depending on the selected sequence, the Playback Buttons are linked to this sequence.
LAST / NEXT CUE
These buttons allow to step backward / forward from cue to cue.
PLAY / PAUSE
This button toggles the selected sequence between the playmodes Play and Pause.