Jitter Reduce Filter

Navigation:  Widget Designer > Nodes > Filter Nodes >

Jitter Reduce Filter

prev main next

Navigation:  Widget Designer > Nodes > Filter Nodes >

Jitter Reduce Filter

prev main next

Please wait. Due to its content this page might take a while to load...

The jitter reduce filter node allows to eliminate jittering input data, for example when using the TrackScan.

The filter updates the output value, if the input is outside the min/max range. If the input is within the min/max range, the last value is on hold.

_img813

Filter Properties:

Input:
Choose input node from list (a delta value).

Min:
Enter minimum value for filtering the jitter from the delta input.

Max:
Enter maximum value for filtering the jitter from the delta input.

The filter generates the following output:
- Jitter Reduce Output.

Example:
Place a delta filter node behind your sensor input node to calculate the jittering delta. In the jitter reduce node choose the delta node output as "Input". If you do not want to route the sensor input data to an output node as long as the delta is between e.g.. -1 and 1, enter these values for min and max. Connect the sensor output node as well to the jitter reduce filter node and choose the sensors output data for "Output".

_img814