Is In Range Filter

Navigation:  Widget Designer > Nodes > Filter Nodes >

Is In Range Filter

prev main next

Navigation:  Widget Designer > Nodes > Filter Nodes >

Is In Range Filter

prev main next

Please wait. Due to its content this page might take a while to load...

The Is In Range filter node checks whether the input point lies within a specific range or outside of it.

This node can be found under Nodes > Filter > Is In Range

wd_nodes_filter_is-in-range

Node properties

Input Value:

Choose an input node from list or enter numeric value.

Min:

Choose an input node from the drop-down or enter a numeric value for the minimum value the input may have to be within the range.

Max:

Choose an input node from the drop-down or enter a numeric value for the maximum value the input may have to be within the range.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The Node generates the following output:

- Output Value: returns the input value if it is within the range. If it is outside, it returns the maximum or minimum value, respective to the input value being higher or lower than the range.

- Result: "-1" if the input value is lower than the minimum, "0" if it is within the range and "1" if it is higher than the maximum