Dynamic Trigger Filter

Navigation:  Widget Designer > Nodes > Filter Nodes >

Dynamic Trigger Filter

prev main next

Navigation:  Widget Designer > Nodes > Filter Nodes >

Dynamic Trigger Filter

prev main next

Please wait. Due to its content this page might take a while to load...

The Dynamic Trigger filter node allows acting as a gate with a given hold and release time and an additional target value. The Dynamic Trigger filter node is one of the few nodes that is related to the sample rate of the node system. When no node property window is opened, the filter works at the given time values. If the updates are increased by open node property dialogs of the node chain, then the timings will be affected. It is recommended to keep all node property dialogs closed when an add relative filter node is being used.

_img811

Filter Properties:

Input:
Choose input node from list or enter numeric value.

Hold Time (ms):
Enter the Hold Time in milliseconds

Release Time (ms):
Enter the Release Time in milliseconds

Release Value:
Enter the Release Value, this will be the minimum value the node gives out.

The filter generates the following output:
- Dynamic Trigger Result