- Default Opacity and Audio Volume is full
When checked, the default value for Opacity is 255 and for Volume it is 0dB, i.e. both are at 100%. This means that as soon as a media file is assigned to a layer, it will be visible or hear-able. When a container is created, and no key for Opacity / Volume is generated, the default value takes place.
In Versions before 5.5 the default value has been 0. If you like to return to that behavior you may uncheck this option.
Please note that this option results in a different show appearance when switched during or after show programming, thus it is recommended to test the show or check this option only once before starting to program.
- Parameter Value Readout
Use the check box to enable percentage readout for all values of all parameters in the project, see figure b) and c). This setting can be changed at any time during runtime.
-- Pixel (where applicable)
This option is available, if the Unit Translation Mode is set to "Use Fixed Relationship".
Some parameters (like Position and most Camera parameters) are then based on pixel values. This makes it possible to enter an exact pixel number, e.g. move right by 50 pixels. With a disabled check box, those parameters are based on generic units as explained here: Configuration > Unit Management.
In Pandoras Box, the positive X-axis points to the right direction and the Y-axis to the top. If you like to have the Y-axis pointing down, make sure, "Invert Y-Axis" is enabled. Both options can also be found in the section "Unit Management".
-- Centered (where applicable): Some of the parameter values appear in centered position by default (default value is here set to 0), irrespective if the readout is decimal or percentage, e.g. the following parameters: X/Y/Z Rotation Speed of a Layer or Keystone faders of an Output. If you disable this function, 0 will be the minimum and the 8 bit /16 bit decimal value (depending on the properties of each parameter) will be the maximum value. With percentage value readout the value range goes from 0 to 100%. Please note that the value parameter or the layer appearance is not changed, it is just a way of displaying the value.
- Initial Values (for Parameter)
Check the option "Link Scale Params" if all newly added layers should have a locked aspect ratio. If you now change the X Scale, the Y and Z scale follow.
For existing layers, you can link parameters by using the chain icon underneath the parameter fields, see Changing Parameter Values (Device Control) and Changing Parameter Values (Device Tree).