Controller Setup

Navigation:  Pandoras Box > User Interface - Master > Tabs Overview > Configuration >

Controller Setup

prev main next

Navigation:  Pandoras Box > User Interface - Master > Tabs Overview > Configuration >

Controller Setup

prev main next

Please wait. Due to its content this page might take a while to load...

The section "SMPTE Time Code" in the Local category from the Configuration tab allows to assign the Sequence faders and Cue buttons for the Christie Jog Shuttle and Fader Extension. Without assigning them here, the controller boards will not work.

configuration_controller-setup_unconnectedGeneral

- Reload
Press this button if the connected controller board is not shown in the tab. This will reload the connection.

- Enable Sequence On/Off Key
This option is valid for the former Jog Shuttle Controllers. The Sequence On/Off Key is enabled by default. This button will toggle the opacity of the selected sequence between 0% and 100%. This option may be disabled so that the sequence cannot be turned off by fault.

- Load Selected Sequence
When this option is enabled, the sequence selected by the sequence faders will be active and loaded into the Sequence Tab.

- Enable Jog Shuttle / Fader Extension
Both check boxes en- or disable the communication with the connected controller boards.

configuration_controller-setup_jog-shuttleJog Shuttle

- Sequence ID
The Jog Shuttle Board allows controlling two sequences. To assign a sequence in Pandoras Box to a Sequence fader and Select button on the Jog Shuttle board, please enter the sequence ID into the text field next to Fader 1 or Fader 2.

- Cue IDs
For each sequence that is linked to the faders, 16 specific cues may be called via the Cue buttons. To assign them:
- Select the Sequence whose cues you want to link to the Cue buttons by clicking on Fader 1 or Fader 2 in the Jog Shuttle section.
- The title of the Cue IDs changes to the Fader number and the Sequence ID linked to this fader.
- Enter a Cue ID for a Cue button.

configuration_controller-setup_fader-extension Fader Extension

If there is a Fader Extension Board attached to the Pandoras Box Master as well, six additional faders and Sequence IDs are shown. Assigning sequences to faders and cues to buttons works in the same way as explained above.