Please wait. Due to its content this page might take a while to load...
The Clip Summary Inspector opens when a container is selected in the Sequence tab.
The container is highlighted with a blue outline.
To change the start timecode of the clip, enter the new timecode using the following syntax: enter e.g. 0:00:06:09 or just 609 to get the new time 0:00:06:09.
To just add e.g. two seconds to the current time, enter "++200", to subtract e.g. two seconds, enter "--200".
To enlarge or to reduce the duration of the clip, enter the new duration using e.g. 0:00:12:00 or just 1200 to get the new duration of 12 seconds.
To just add e.g. two seconds to the current duration, enter "++200", to subtract e.g. two seconds, enter "--200".
The Clip Color is the color the container is filled with. Per default it is gray. In case you set it to "Transparent" it will be of the same color the Layer is set to (see Layer Color). By clicking into the color field a dialog opens where you can choose any other color for the container.
Note that in case you have chosen Clip Colors in File Inspectors, they are overwritten with individual container colors. If you like to reset the container to be colored according to the File Inspector, click "Reset".
All settings below the line are taken from the Clip Inspector.