Clip Remaining Time

Navigation:  Widget Designer > Nodes > Input Nodes > Pandoras Box Input >

Clip Remaining Time

prev main next

Navigation:  Widget Designer > Nodes > Input Nodes > Pandoras Box Input >

Clip Remaining Time

prev main next

Please wait. Due to its content this page might take a while to load...

The Clip Remaining Time node provides the remaining time of a clip in Pandoras Box. The nowpointer must be inside the clip container, the remaining time is calculated by the nowpointer's position relating to the end of the container.

The node can be found under Nodes > Input Nodes > Pandoras Box > Clip Remaining Time

wd_nodes_input_clip-remaining-time

Node properties

Sequence ID:

Enter the Sequence ID.

Site ID:

Enter the Site ID.

Device ID:

Enter the Device ID.

Node control

With Widget Designer version 6, all nodes support so called node commands. Node commands access functions (i.e methods) from a node and / or set a parameter (i.e. property).

Enter "node", followed by the according ID and a dot and a list will pop up showing all available commands for the node. For instance, Node1.TintColor.SetRGB(125,0,255), colors the node in purple.
In addition, the node properties with a parameter ID (the small superscript number) can be edited via the command Node1.SetParam(ID,new Value) or WDNodeSetParam(NodeID,ParamID,Value).

Node output values

The Node generates the following output:

 

- Master Hour

- Master Minute

- Master Second

- Master Frame

- Backup Hour

- Backup Minute

- Backup Second

- Backup Frame

- TC Master

- TC Backup