AKAI APC40

Navigation:  Widget Designer > Tools > Midi Input >

AKAI APC40

prev main next

Navigation:  Widget Designer > Tools > Midi Input >

AKAI APC40

prev main next

Please wait. Due to its content this page might take a while to load...

If you wish to use an additional Midi Interface to control Widget Designer you may choose a AKAI APC40 to map its buttons and fader to commands, parameters and value ranges.

_img1004

The AKAI APC40 allows using a separate Midi input device which is set up in the top section of the AKAI APC40 Editor:

To enable the Midi Input for the AKAI APC 40 board please choose your Midi Receive Device from the list and press [Apply].

Tick the check box [Enable] to enable the AKAI APC 40 board and remove the check if you want to disable the device again.

Once connected to the AKAI APC40 you may press a button or move a control to let Widget Designer intercept and give you access to the Controls scripts or Fader Encoder Settings.

To change any setting press on the control, enter your values and press [Apply].