3D Hardware

Navigation:  Pandoras Box > User Interface - Master > Tabs Overview > Configuration >

3D Hardware

prev main next

Navigation:  Pandoras Box > User Interface - Master > Tabs Overview > Configuration >

3D Hardware

prev main next

Please wait. Due to its content this page might take a while to load...

3dconnexion-spacenavigatorconfiguration_3d-hardware

Any Pandoras Box Master versions support the product SpaceNavigator from 3Dconnexion. In short, this is a mouse device that allows to navigate in three axes (position and rotation). Make sure to install its driver.

The check box "Enable 3D Mouse Input" en- and disables the communication with the mouse device.

The below drop-down list offers two options. With "Control Preview Camera" you can control the camera selected in the Preview tab and with "Control selected Layers" you control this or those layer(s) that are currently selected in the Device Tree. Note that the mouse input alters the parameters relatively, not absolutely.

The check box "Use Preview transformation constraints" refers to the constraints along the X-,Y- and / or Z-axis set up in the Preview tab. This is explained in more detail in the chapter Layer Mode and Camera Transformation Mode.